The renewal process for melters begins with the complete disassembly of the unit. The hydraulic section is stripped and recoated with a high performance non-stick coating. Tanks, frames, and sheet metal are stripped and cleaned of all traces of adhesive using a proprietary process. All surfaces exposed to adhesive are then coated with our specialty release coating. Pumps, filters, motors, and other wear components are renewed or replaced. The entire unit is reassembled using all new seals and gaskets. The unit is fully tested and pressure checked at a huge cost savings over new. Available upgrades include: addition of pumps and drives, addition of UMI (universal machining interface) kit, installation of additional hose/gun channels, pump capacities, and holding capacities.